User Manual Part 1

Tools and Materials

FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 65

3.2 TOOLS AND MATERIALS

The following tools are required to complete the procedures in this section:

•• Medium size flat-bladed screwdriver

•• Phillips screwdriver (#2)

•• Pliers

•• Wire cutters

•• Wire stripper

•• Tool kit for attaching QMA-Type male connectors to coaxial cable

•• Crimp tool to attach ring terminals

•• Multimeter

•• Optical power meter

•• Fiber cleaning equipment

The following materials are required to complete the procedures in this section:

•• #18 AWG (1.0 mm) insulated stranded copper wire (for chassis grounding wire)

•• #18 AWG (1.0 mm) red and black insulated copper wire (for DC power wires)

•• Category 3 or 5 cable (for external alarm system wires)

•• Category 5 cable with RJ45 connectors for the Network and Craft port

•• #6 ring terminal (1) for #18 wire (for chassis ground wire connection)

•• #6 fork terminals (2) for #18 wire (for DC power wiring connection)

•• Single-mode patch cord(s) with LC connectors (1 – 8 depending on the application)

•• High performance, flexible, low-loss 50-ohm coaxial cable

•• QMA-type male connectors

•• Wire ties