User Manual Part 1

Prism Remote Units
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 35
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
2.3 PRISM REMOTE UNITS
The Remote, shown in Figure 2-4, controls RF emissions, interfaces with the FlexWave
Host and performs the optical to electrical conversions for transport to the antennas.
The Remote is an environmentally-sealed unit that houses the electronic assemblies
such as the DART board and the Power Amplifier, and seals out dirt and moisture.
The Prism uses fans located on the top of each unit to cool the chassis. The antenna
cable connectors, fiber connectors, AC power connector, and the unit status indicator
are located on the bottom of the unit.
Figure 2-4. Prism Remote Units
Single-Band Remote Dual-Band Remote
Tri-Band Remote
Quad-Band Remote
77073-007