User's Manual

Link the Host and Remote DARTs.
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 163
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
The
Configuration Details
table has the following columns:
•
Host DART Id
—Slot number of slot occupied by the Host DART card. The Host
has eight slots numbered from 1 to 8, read from top to bottom. If the Host
DART is a 12-Timeslot DART, then only the first of the two slots it occupies
will be shown (for example, if the Host 12-Timeslot DART occupies slots 1 and
3, only slot 1 will be shown).
•
Host DART SFP Id
—Port number of physical optical port where Host-Remote
optical fiber is connected on the Host.
•
Host DART Band
—Frequency band of the Host DART. This field is not
configurable and reports the DART type (such as, cellular, pcs, and so forth).
•
Host DART Pass Band
—Passband assigned to the specified Host DART.
•
Host DART Status
—System entered status of Host DART card. This will be active,
standby, or not in service
•
Remote DART Id
—Number (1-8) indicating the physical location where this
DART card is mounted in the Remote; see “RF Groups in the Remote and the
EMS GUI” on page 160) for an explanation of how the Remote DARTs are
numbered.
•
Remote DART SFP Id
—Shows the available Remote SFPs that can be used to link
the DARTs.
1
is shown in this example, so the Remote has fibers connected to
this Host using Remote SFP 1. If there are two or more sets of SFPs connected
between the same Host DART and Remote DART, this field will contain a value
such as
2/3
or
2/3/4
where each one-digit number represents one Remote
optical port where an SFP is connected for this Host/Remote pair. Each set of
one Host SFP and one Remote SFP supports two optical fibers (RX and TX), each
with a capacity of 12 TDM timeslots
•
Remote DART Status
—System entered status of Remote DART card, which can
be
active
or
unlink
•
Decommission
button—used to clean out settings and information for
hardware that has been removed.
•
LPA Reset
button—When clicked, causes the LPA to reset as described in
“Restarting an LPA” on page 236.
366 To link the Host DART to the Remote DART for this pass band, click in the radio
button next to Host DART Id (ID
1
in this example).