User's Manual

FlexWave Prism Host, Remote and EMS 5.1 System Reference Page xiii

STANDARDS CERTIFICATION

FCC:: This equipment complies with the applicable sections of Title 47 CFR Part 15

(Host unit), Part 22 (800 MHz Cellular), Part 24 (1900 MHz - PCS), Part 90 (800/900 -

SMR), and Part 27 (2100 MHz - AWS).

IC:: This equipment complies with the applicable sections of RSS-131. The term “IC:”

before the radio certification number only signifies that Industry Canada Technical

Specifications were met.

The Manufacturer's rated output power of this equipment is for single carrier

operation. For situations when multiple carrier signals are present, the rating would

have to be reduced by 3.5 dB, especially where the output signal is re-radiated and

can cause interference to adjacent band users. This power reduction is to be by

means of input power or gain reduction and not by an attenuator at the output of the

device.

Note:: To comply with Maximum Permissible Exposure (MPE) requirements, the

maximum composite output form the antenna cannot exceed 1000 Watts ERP

(Cellular and SMR), the antenna cannot exceed 1640 Watts EIRP (PCS), and the antenna

must be permanently installed in a fixed location that provides at least 6 meters (20

feet) of separation from all persons.

UL/CUL:: This will be installed in a restricted access location. This equipment

complies with NEMA Type 4, per UL and CUL 50, Standard for Enclosures for Electrical

Equipment. This equipment provides the degree of protection specified by IP65 as

defined in IEC Publication 529.

FDA/CDRH:: This equipment uses a Class 1 LASER according to FDA/CDRH Rules.

This product conforms to all applicable standards of 21 CFR Part 1040.

Caution:: Modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

EU Harmonized Standardss: Meets essential requirements of R&TTE 1999/5/EC.

•• Article 3.1a—The protection of the health and the safety of the user and any other

person, including the objectives with respect to safety requirements contained in

Directive 2006/95/EC, but with no voltage limit applying.

•• Article 3.1b—The protection requirements with respect to electromagnetic

compatibility contained in Directive 2004/108/EC.

•• Article 3.2—In addition, radio equipment shall be so constructed that it effectively

uses the spectrum allocated to terrestrial/space radio communication and orbital

resources so as to avoid harmful interference.

EMC Standards:: EN 55022 and EN55024 (CE marked)

Safety Standards:

•• IEC 60950-1, First Edition (CE marked)

•• UL 60950-1 (File number E174166) (USA and Canada)