User's Manual

Managing Remote Units
Page 230 FlexWave Prism Host, Remote and EMS 5.1 System Reference
© 2009 ADC Telecommunications, Inc ADCP-77-073 • Issue 2 • 11/2009
10.1 VIEWING REMOTE SERF ETHERNET PORTS
The Remote SERF ENET page is a summary of throughput and number of errors on
the twelve Ethernet (ENET) ports on the Remote SeRF card. These ports, located on
the front side of the SeRF card, consist of eight ports used for connection to Remotes
and four ports used for system management and maintenance functions.
To open the
ENET Configurations
view in the EMS View Frame, in the Function Explorer
Tree select
System View
,
Remotes
,
SERF
,
ENET
.
The
ENET Configurations
view lists the Ethernet ports and their corresponding status.
•
Switch Port
—on card processor's connection to the switch on the SeRF card
•
Craft Port
—on card processor's connection to the PHY port labeled Craft
•
OptEnetPort1-8
—Ethernet switch interface to SFP 1-8
•
Network Port
—Ethernet switch interface to on-card processor
•
Management Port
—switch interface to the PHY port labeled Network
•
Rx Bytes
—Receive byte counter. Increments by the byte count of frames received,
including those in bad packets, excluding preamble and SFD but including FCS
bytes
•
Rx Pkts
—Receive packet counter. Increments for each frame received packet
(including bad packets, all unicast, broadcast, and multicast packets)
•
Rx FSC Errors
—Receive FCS error counter. Increments for each frame received that
has an integral 64 to 1518 length and contains a frame check sequence error