Manualshelf

User's Manual

ManualsBrandsADC Telecommunications ManualsElectronicsFlexWave Prism - 700 Lower ABC - Band
111112113114115116117118119120
SeRF Card Replacement Procedure
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 323
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
66 Do one of the following:
•• If you plan to reconfigure the system once the new SeRF is installed, skip to
Section A.5.2, Installing a New DART Card in the Host Chassis, on page 325.
•• If you will be removing the Compact Flash card from the old SeRF and
installing it into the new SeRF before installing the SeRF card in the Host, go
to Section A.4.3, Swap Compact Flash From Old SeRF Card to New SeRF Card,
on page 323.
A.4.3 Swap Compact Flash From Old SeRF Card to New
SeRF Card
77 Remove the Compact Flash card from the new SeRF card by gently lifting the
Compact Flash card out of its holder.
88 Slide the Compact Flash removed from the old SeRF card into the new SeRF card.
Install the Compact Flash card label side up, and with the connectors pointing
toward the middle of the SeRF card. Gently push the Compact Flash card in until
it is firmly seated.
Do not complete this procedure if you are going to reconfigure the URH system after you
install the n
ew SeRF card—skip to “Install New SeRF Card” on page 324.
75348p2-0001
Compact Flash card
SeRF card