User's Manual

SeRF Card Replacement Procedure
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 319
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
A.4 SERF CARD REPLACEMENT PROCEDURE
Replacing the SeRF card is a 14-step procedure that is broken into four sections,
Follow the steps in the order given.
A.4.1 Preserve System Configuration
11 Before you start the procedure to replace the SeRF card, decide how you will
restore the system configuration, which can be accomplished in one of two ways:
•• Option A—You can remove the Compact Flash card from the old SeRF and
install it into the new SeRF before installing the SeRF card in the Host.
•• Option B—You can reconfigure the system once the new SeRF is installed. If
you are going to reconfigure the system, before you remove the SeRF card,
record the system settings in Table A-1, including frequency bands, gain and
delay settings, module names and network information.
Removing the SeRF Card will disable the Host and interrupt service. The entire system
configuration i
s stored on the Compact Flash card on the SeRF. If you replace the SeRF
with a new one, the system w
ill NOT be operational immediately following replacement.
Notify the NOC or alarm monitoring system o
perator that the system will be Out of
Service (OOS) for a period of time.
Table A-1. URH System Configuration
EMS VIEW PARAMETER SETTING
IP ADDRESSES
Host Network port IP address
Host Craft port IP address
Remote 1 IP address
Remote 2 IP address
Remote 3 IP address
Remote 4 IP address
Remote 5 IP address
Remote 6 IP address
Remote 7 IP address
Remote 8 IP address
HOST CONFIGURATION
Host Summary Host Name
10 MHz Reference Clock
Optical Ports view for the Host Optical Port 1 name
Optical Port 2 name
Optical Port 3 name
Optical Port 4 name