User's Manual

Application Note 16 – version 1.1
page 7
p
plication Note
A
13) After bootup, verify that the front-panel LEDs are lit as follows: SCN (on IWP card only) lit, PWR
lit, ON LINE on IWP and E1 or T1 cards lit, FLT not lit. Note that the ON LINE LEDs on the TRX
cards are not lit until they are unlocked by the OMC operator.
If the LED displays are different than that shown in this and the previous step, the TurboMAX has
not passed the POST. Contact Technical Support for further information.
14) Set up a Craft PC with dedicated ethernet and serial connections as shown in Figure 3 and 4,
respectively.
ON/LINE
PORT 1
12
PORT 0
12
ALARMS
FLT
PWR
ALARMS
IWP, 64MEG, MMU
HARD DISK
ON
LINE
PWR
FLT
SCN
RST
CON
ENET
EXT
XREF
IW206002
AUI-BNC
Transceiver
Ethernet
Port
BNC
T-Connector
50 Ohm terminators
BNC T-Connector
RG-58 coaxial cable
3Com Combo
transceiver
PCMCIA
card slot
Craft PC
Figure 3. Connecting the Craft PC to the TurboMAX via the Ethernet Port