Installation Manual

ManualsBrandsADC Telecommunications ManualsElectronicsWavXpress PCS Base Station

Table Of Contents

WAVEXpress/BTS Installation and Commissioning Guide
One - Unpacking the WAVEXpress/BTS
Two - Internal BTS Cabling and Jumpering
- 2-1 Cabling Specifications
- 2-2 Connection of Cables within the BTS
Three - Installation
Four - Off-Line Commissioning
- 4-1 Pre Off-Line Commissioning Checks
  - 4-1.1 Pre Off-Line Commissioning Visual Checks
- 4-2 Off-Line Commissioning Set-up
  - 4-2.1 T1 Lines and Power Configuration
  - 4-2.2 Power On Self Test (POST) Diagnostics
Five - Off-Line Commissioning of a Daisy Chain
Six - Post Off-Line Commissioning
- 6-1 Post Off-Line Commissioning
  - 6-1.1 Post Off-Line Commissioning Procedures at the Staging Area
  - 6-1.2 Post Off-Line Commissioning Procedures On-Site
Seven - On-Line Commissioning
- 7-1 Introduction
  - 7-1.1 Pre On-Line Commissioning Requirements
  - 7-1.2 Prerequisites for Network Integration
- 7-2 On-Line Commissioning
  - 7-2.1 Post On-Line Commissioning Procedures
Appendix 1 - Connection of the Combiner Assembly
- A1-1 Introduction
- A1-2 Equipment Description
Appendix 2 - BTS Field Maintenance
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
Checklist 1 - Installation Checklist
Checklist 2 - Commissioning Checklist

Release 3.3, Revision A 1/99

72 WAVEXpress/BTS Installation and Commissioning Guide

Checking the IWP Flash Version Number

In order to verify that the correct software build is loaded into flash memory, go to an XTerm window by placing your

cursor in it and type:

bts:A->

printConfigBlocks

The following screen containing information relating to the two flash images (labeled Primary Config Block and

Secondary Config Block) is displayed:

NOTE

☛

Refer to the Craft PC Guide for instructions if the V2R4 kernel is not loaded on the

WAVEXpress/BTS (i.e. V2R3).