Installation Manual
Table Of Contents
- WAVEXpress/BTS Installation and Commissioning Guide
- One - Unpacking the WAVEXpress/BTS
- Two - Internal BTS Cabling and Jumpering
- Three - Installation
- 3-1 Wall Installation
- 3-2 Table Mount
- 3-3 Rack Installation
- 3-4 Common Final Installation Procedures
- 3-4.1 Connection of the Cable Gland
- 3-4.2 Connection of the Grounding Cable
- 3-4.3 Connection of the Antennas to the Bulkhead Plate
- 3-4.4 Connection of the Optional Combiner Assembly
- 3-4.5 Connection of the Power Supply
- 3-4.6 Connection of the T1 Lines
- 3-4.7 Connection to External Alarms
- 3-4.8 Optional Voltage Standing Wave Ratio (VSWR) Check
- 3-4.9 Post Installation Checks
- 3-5 Outdoor Installation
- Four - Off-Line Commissioning
- Five - Off-Line Commissioning of a Daisy Chain
- Six - Post Off-Line Commissioning
- Seven - On-Line Commissioning
- Appendix 1 - Connection of the Combiner Assembly
- Appendix 2 - BTS Field Maintenance
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- A2-1.1 Replacing the WAVEXpress/BTS IWP card
- A2-1.2 Replacing the WAVEXpress/BTS T1 card
- A2-1.3 Replacing the WAVEXpress/BTS TRX card
- A2-1.4 Replacing the WAVEXpress/BTS RF distribution card
- A2-1.5 Replacing the clock module
- A2-1.6 Replacing power supply units
- A2-1.7 Replacing fan assemblies
- A2-1.8 Replacing filters (p/n 520081-01)
- A2-1.9 Replacing the antenna bracket with a combiner assembly
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- Checklist 1 - Installation Checklist
- Checklist 2 - Commissioning Checklist
Release 3.3, Revision A 1/99
Installation 29
3-1.1 Installation Instructions
Step 1
Mount the attachment plate to the wall, in the desired location, using customer-provided screws suitable
for the wall material (wood, concrete, plaster, sheet metal).
Step 2
Position the keyhole plate on the side of the WAVEXpress/BTS which will be mounted to the wall. Ensure
that the narrow end of the keyhole points upwards.
Step 3
Attach the keyhole plates (shown in Figure 3-2 : "View of the side mounted keyhole plates" on page 30)
to the chassis in the desired location using two 10-32 machine screws and washers per keyhole plate.
These keyhole plates can be mounted in three locations on the chassis, namely:
• to the back of the BTS chassis
• to the left side of the BTS chassis
• to the right side of the BTS chassis
The flat side of the back of the attachment plate must be flush with the wall
surface.
Figure 3-1:
Front view of the attachment plate
!
%ROW#KROHV#IRU
PRXQWLQJ
SODWH#WR#ZDOO
%ROWV#IRU
PRXQWLQJ#WKH
%76#WR#SODWH
:DOO%76