Installation Manual
Table Of Contents
- WAVEXpress/BTS Installation and Commissioning Guide
- One - Unpacking the WAVEXpress/BTS
- Two - Internal BTS Cabling and Jumpering
- Three - Installation
- 3-1 Wall Installation
- 3-2 Table Mount
- 3-3 Rack Installation
- 3-4 Common Final Installation Procedures
- 3-4.1 Connection of the Cable Gland
- 3-4.2 Connection of the Grounding Cable
- 3-4.3 Connection of the Antennas to the Bulkhead Plate
- 3-4.4 Connection of the Optional Combiner Assembly
- 3-4.5 Connection of the Power Supply
- 3-4.6 Connection of the T1 Lines
- 3-4.7 Connection to External Alarms
- 3-4.8 Optional Voltage Standing Wave Ratio (VSWR) Check
- 3-4.9 Post Installation Checks
- 3-5 Outdoor Installation
- Four - Off-Line Commissioning
- Five - Off-Line Commissioning of a Daisy Chain
- Six - Post Off-Line Commissioning
- Seven - On-Line Commissioning
- Appendix 1 - Connection of the Combiner Assembly
- Appendix 2 - BTS Field Maintenance
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- A2-1.1 Replacing the WAVEXpress/BTS IWP card
- A2-1.2 Replacing the WAVEXpress/BTS T1 card
- A2-1.3 Replacing the WAVEXpress/BTS TRX card
- A2-1.4 Replacing the WAVEXpress/BTS RF distribution card
- A2-1.5 Replacing the clock module
- A2-1.6 Replacing power supply units
- A2-1.7 Replacing fan assemblies
- A2-1.8 Replacing filters (p/n 520081-01)
- A2-1.9 Replacing the antenna bracket with a combiner assembly
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- Checklist 1 - Installation Checklist
- Checklist 2 - Commissioning Checklist
Internal BTS Cabling and Jumpering 15
Release 3.3, Revision A 1/99
Two
Internal BTS Cabling and Jumpering
This chapter describes all internal cabling connections needed to be made for the BTS to operate. This cabling needs
to be connected and checked before the WAVEXpress/BTS is installed.
2-1 Cabling Specifications
Listed below is the internal cabling supplied with the WAVEXpress/BTS:
Table 2-13:
Supplied cabling
Cable Identity Quantity
Required Cables for an
Indoor BTS
Required Cables for an
Outdoor BTS
Power up to 2* IEC 320 IEC 320
Antenna- RF Dist
•-1-
•-2-
•-3-
1-3*
Two cable sets shipped:
• SMA semi-rigid to
female N-type
• SMA semi-rigid to
male N-type
SMA semi-rigid to
female N-type
TRX
• Tx 2,3 cable
• Tx 4,5 cable
• Tx 6,7 cable
• Rx 2,3 cable
• Rx 4,5 cable
• Rx 6,7 cable
2-6*
SMA semi-rigid to SMA
semi-rigid
SMA semi-rigid to SMA
semi-rigid
Internal clock 1
SMA semi-rigid to SMA
semi-rigid
SMA semi-rigid to SMA
semi-rigid
External alarm 1 RJ45 to terminal block RJ45 to terminal block
NOTE
☛
* The number of cables shipped depend on the configuration of the system
ordered.