Installation Manual
Table Of Contents
- WAVEXpress/BTS Installation and Commissioning Guide
- One - Unpacking the WAVEXpress/BTS
- Two - Internal BTS Cabling and Jumpering
- Three - Installation
- 3-1 Wall Installation
- 3-2 Table Mount
- 3-3 Rack Installation
- 3-4 Common Final Installation Procedures
- 3-4.1 Connection of the Cable Gland
- 3-4.2 Connection of the Grounding Cable
- 3-4.3 Connection of the Antennas to the Bulkhead Plate
- 3-4.4 Connection of the Optional Combiner Assembly
- 3-4.5 Connection of the Power Supply
- 3-4.6 Connection of the T1 Lines
- 3-4.7 Connection to External Alarms
- 3-4.8 Optional Voltage Standing Wave Ratio (VSWR) Check
- 3-4.9 Post Installation Checks
- 3-5 Outdoor Installation
- Four - Off-Line Commissioning
- Five - Off-Line Commissioning of a Daisy Chain
- Six - Post Off-Line Commissioning
- Seven - On-Line Commissioning
- Appendix 1 - Connection of the Combiner Assembly
- Appendix 2 - BTS Field Maintenance
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- A2-1.1 Replacing the WAVEXpress/BTS IWP card
- A2-1.2 Replacing the WAVEXpress/BTS T1 card
- A2-1.3 Replacing the WAVEXpress/BTS TRX card
- A2-1.4 Replacing the WAVEXpress/BTS RF distribution card
- A2-1.5 Replacing the clock module
- A2-1.6 Replacing power supply units
- A2-1.7 Replacing fan assemblies
- A2-1.8 Replacing filters (p/n 520081-01)
- A2-1.9 Replacing the antenna bracket with a combiner assembly
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- Checklist 1 - Installation Checklist
- Checklist 2 - Commissioning Checklist
Release 3.3, Revision A 1/99
8 WAVEXpress/BTS Installation and Commissioning Guide
1-3.4 interWAVE Processor (IWP) Card
The following table describes the function of the connectors and indicators on a
WAVEXpress/BTS IWP card. Refer to the illustration on the left for the position of connectors
and indicators.
Table 1-4:
WAVEXpress/BTS IWP card’s connectors and indicators
Connector or
Indicator
Function
RST This button resets the card.
SCN When lit, the system controller LED indicates the IWP is
operational.
PWR Green LED, lit when card has power supplied.
ONLINE Green LED, lit when card is on-line, downloaded, and
card boot process has been performed successfully.
FLT Red LED, lit when the card detects a fault or the card has
not downloaded successfully.
CON 9-pin, RS232 connector for serial connection to the Craft
PC.
ENET 15-pin, DB-15 connector for Ethernet connection to the
Craft PC.
EXT RJ45 for external alarm connection.
XREF SMA connector for input from external clock for system
synchronization.
NOTE
☛
A BTS 16Mb IWP card has the part number 340123. This part numbers is visible
on the front face of the IWP card.
ON
LINE
PWR
FLT
SCN
RST
CDN
ENET
EXT
XREF
IW352802
IWP, 16MEG, MMU