Installation Manual

Unpacking the WAVEXpress/BTS 1
Release 3.3, Revision A 1/99
One
Unpacking the WAVEXpress/BTS
The WAVEXpress/BTS was packed with great care, and all containers were inspected prior to shipment. Upon receipt
of these packages, immediately inspect the outside of the shipping containers. If there is any visible damage, insist that
a representative of the carrier be present when unpacking the contents.
Carefully inspect the system as it is unpacked. If any damage such as dents or broken connections is noticeable,
immediately notify the carrier as well as the interWAVE Communications Solution Center.
Store the shipping containers for future use. If the unit has to be returned for upgrade or service, the specially designed
shipping containers assure adequate protection for the equipment. If for some reason the containers are not reusable
or if they are misplaced, please contact interWAVE to order new containers.
1-1Configuration Labels
There are four configuration labels which placed on the front of each of the WAVEXpress modules as well as the chassis
to help identify the system’s current configuration. The four labels identify the part's:
• Identity
•Part number
• Revision number
• Serial number
An example of a configuration label is shown in the following figure:
Figure 1-1:
Example of the four configuration labels
T1
LH, 2 PORT, ETH
P/N 340127
-200
S/N 00719500
Description of part
Part number
Dash or revision number
Serial number
Barcode identifier of
the part number
Barcode identifier of
the rev number
Barcode identifier of
the serial number
IW352801