Installation Manual

ManualsBrandsADC Telecommunications ManualsElectronicsWavXpress PCS Base Station

Table Of Contents

WAVEXpress/BTS Installation and Commissioning Guide
One - Unpacking the WAVEXpress/BTS
Two - Internal BTS Cabling and Jumpering
- 2-1 Cabling Specifications
- 2-2 Connection of Cables within the BTS
Three - Installation
Four - Off-Line Commissioning
- 4-1 Pre Off-Line Commissioning Checks
  - 4-1.1 Pre Off-Line Commissioning Visual Checks
- 4-2 Off-Line Commissioning Set-up
  - 4-2.1 T1 Lines and Power Configuration
  - 4-2.2 Power On Self Test (POST) Diagnostics
Five - Off-Line Commissioning of a Daisy Chain
Six - Post Off-Line Commissioning
- 6-1 Post Off-Line Commissioning
  - 6-1.1 Post Off-Line Commissioning Procedures at the Staging Area
  - 6-1.2 Post Off-Line Commissioning Procedures On-Site
Seven - On-Line Commissioning
- 7-1 Introduction
  - 7-1.1 Pre On-Line Commissioning Requirements
  - 7-1.2 Prerequisites for Network Integration
- 7-2 On-Line Commissioning
  - 7-2.1 Post On-Line Commissioning Procedures
Appendix 1 - Connection of the Combiner Assembly
- A1-1 Introduction
- A1-2 Equipment Description
Appendix 2 - BTS Field Maintenance
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
Checklist 1 - Installation Checklist
Checklist 2 - Commissioning Checklist

BTS Field Maintenance 107

Release 3.3, Revision A 1/99

Appendix 2

BTS Field Maintenance

A2-1WAVEXpress/BTS Field Replacement Maintenance

This section contains the BSS field replacement maintenance procedures for the WAVEXpress/BTS. WAVEXpress/

BTS field replacement maintenance includes the field replacement actions of the following cards and modules:

•IWP card

•T1 card

•TRX card

• RF Distribution card

• clock module

• power supply units

• fan assemblies

•filters

• combiner assembly.