Installation Manual
Table Of Contents
- WAVEXpress/BTS Installation and Commissioning Guide
- One - Unpacking the WAVEXpress/BTS
- Two - Internal BTS Cabling and Jumpering
- Three - Installation
- 3-1 Wall Installation
- 3-2 Table Mount
- 3-3 Rack Installation
- 3-4 Common Final Installation Procedures
- 3-4.1 Connection of the Cable Gland
- 3-4.2 Connection of the Grounding Cable
- 3-4.3 Connection of the Antennas to the Bulkhead Plate
- 3-4.4 Connection of the Optional Combiner Assembly
- 3-4.5 Connection of the Power Supply
- 3-4.6 Connection of the T1 Lines
- 3-4.7 Connection to External Alarms
- 3-4.8 Optional Voltage Standing Wave Ratio (VSWR) Check
- 3-4.9 Post Installation Checks
- 3-5 Outdoor Installation
- Four - Off-Line Commissioning
- Five - Off-Line Commissioning of a Daisy Chain
- Six - Post Off-Line Commissioning
- Seven - On-Line Commissioning
- Appendix 1 - Connection of the Combiner Assembly
- Appendix 2 - BTS Field Maintenance
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- A2-1.1 Replacing the WAVEXpress/BTS IWP card
- A2-1.2 Replacing the WAVEXpress/BTS T1 card
- A2-1.3 Replacing the WAVEXpress/BTS TRX card
- A2-1.4 Replacing the WAVEXpress/BTS RF distribution card
- A2-1.5 Replacing the clock module
- A2-1.6 Replacing power supply units
- A2-1.7 Replacing fan assemblies
- A2-1.8 Replacing filters (p/n 520081-01)
- A2-1.9 Replacing the antenna bracket with a combiner assembly
- A2-1 WAVEXpress/BTS Field Replacement Maintenance
- Checklist 1 - Installation Checklist
- Checklist 2 - Commissioning Checklist
Release 3.3, Revision A 1/99
78 WAVEXpress/BTS Installation and Commissioning Guide
Step 3
The above display shows that the TRX POST diagnostics ran successfully on the TRX card in slot 6 but
failed on the TRX card in slot 4. The final results of the TRX POST for both cards are highlighted in grey
in the illustration above.
Step 4
If the TRX card(s) passed the POST diagnostics successfully, then reboot the WAVEXpress/BTS to
place the TRX card(s) in an on-line and operational status by typing:
bts:A->
reboot
[ENTER]
Figure 4-9:
TRX POST results (Page 3)
91 (Diag) TRX(4) TF62: Verify TDM FPGA download : PASSED
92 (Diag) TRX(4) TF63: TDM control store RAM : PASSED
93 (Diag) TRX(4) TF66: TDM clocks and interface : PASSED
94 (Diag) TRX(4) TF87: Download RXTDMA FPGA : PASSED
95 (Diag) TRX(4) TF65: Verify RXTDMA FPGA download : PASSED
96 (Diag) TRX(4) TF88: Download TXTDMA FPGA : PASSED
97 (Diag) TRX(4) TF64: Verify TXTDMA FPGA download : PASSED
98 (Diag) TRX(4) TF40: Test DSP3 to DSP1 FIFO : PASSED
99 (Diag) TRX(4) TF41: Test DSP4 to DSP2 FIFO : PASSED
100 (Diag) TRX(4) TF42:Test DSP1-TXTDMA FIFO via RTP access: PASSED
101 (Diag) TRX(4) TF43:Test DSP2-TXTDMA FIFO via RTP access: PASSED
102 (Diag) TRX(4) TF44:Test DSP3-RXTDMA FIFO via RTP access: PASSED
103 (Diag) TRX(4) TF45:Test DSP4-RXTDMA FIFO via RTP access: PASSED
104 (Diag) TRX(4) TF31: Load & verify start-up of DSP1 : PASSED
105 (Diag) TRX(4) TF32: Load & verify start-up of DSP2 : PASSED
106 (Diag) TRX(4) TF33: Load & verify start-up of DSP3 : PASSED
107 (Diag) TRX(4) TF34: Load & verify start-up of DSP4 : PASSED
108 (Diag) TRX(4) TF30: Load & verify startup of DSP1-4 : PASSED
109 (Diag) TRX(4) TF36: DSP1 ping test : PASSED
110 (Diag) TRX(4) TF37: DSP2 ping test : PASSED
111 (Diag) TRX(4) TF38: DSP3 ping test : PASSED
112 (Diag) TRX(4) TF39: DSP4 ping test : PASSED
113 (Diag) TRX(4) TF35: Ping-test DSP1-4 : PASSED
114 (Diag) TRX(4) TF58: DSP test of DSP1 to DSP3's FIFO : PASSED
115 (Diag) TRX(4) TF59: DSP test of DSP2 to DSP4's FIFO : PASSED
116 (Diag) TRX(4) TF46: Test DSP1 to TDM Serial Loop Test : PASSED
117 (Diag) TRX(4) TF47: Test DSP2 to TDM Serial Loop Test : PASSED
118 (Diag) TRX(4) TF48: Test DSP3 to TDM Serial Loop Test : PASSED
119 (Diag) TRX(4) TF54: DSP fill test of DSP1-TXTDMA FIFO : PASSED
120 (Diag) TRX(4) TF55: DSP fill test of DSP2-TXTDMA FIFO : PASSED
121 (Diag) TRX(4) TF56: DSP read test of DSP3-RXTDMA FIFO : PASSED
122 (Diag) TRX(4) TF57: DSP read test of DSP4-RXTDMA FIFO : PASSED
123 (Diag) TRX(4) TF71: Disable all IRQs to VME : FAILED
124 (Diag) TRX(4) TF78: Clear all DSP/RTP to VME IRQs : FAILED
125 (Diag) TRX(4) TF11:Fast Test Suite (all but VME EEPROM): FAILED
126 (Diag)
TRX CARD IN SLOT 4:COMPLETED TRX POST OFFLINETest: FAILED