User's Manual Part 2

December 20, 2004 SCP-LPS20x-011-012-01H
ADC Telecommunications, Inc. 173
REGULATORY, WIRELESS INTEROPERABILITY, AND HEALTH
INFORMATION
REGULATORY INFORMATION
The LPS-20x complies with the following radio frequency and safety standards.
CANADA - INDUSTRY CANADA (IC)
This device complies with RSS 210 of Industry Canada. Cet appareil numérique de la classe B est conforme à la
norme NMB-003 et CNR 210 d’Industrie Canada.
EUROPE - EU DECLARATION OF CONFORMITY
This device is for indoor use only.
USA - FEDERAL COMMUNICATIONS COMMISSION (FCC)
The LPS-20x complies with Part 15 of FCC Rules. Operation of the LPS-20x in a system is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesired operation.
Caution: Exposure to Radio Frequency Radiation
The radiated output power of the LPS-20x is far below the FCC radio frequency exposure limits. Nevertheless, the
LPS-20x should be used in such a manner as to minimize the potential for human contact during normal operation.
When using this device in combination with ADC antenna products, a certain separation distance between the
antenna and nearby persons has to be kept to ensure RF exposure compliance.
Refer to the Regulatory Statements as identified in the documentation that comes with those products for additional
information.
When an external antenna is connected to the LPS-20x, it shall be placed in such a manner as to minimize the
potential for human contact during normal operation. To avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.
When no external antenna is connected, the RF output power of the LPS-20x is far below the FCC radio frequency
exposure limits. Nevertheless, it is advised to use the LPS-20x in such a manner that human contact during normal
operation is minimized.
!
IMPORTANT
Users must select the proper country of operation when ordering to ensure wireless operational
settings conform to local regulations.
If more than one unit is deployed, users must ensure that the operating frequencies are spread
among different channels (according to channel availability).