User's Manual Part 2

December 20, 2004 SCP-LPS20x-011-012-01H
ADC Telecommunications, Inc. 133
AGENT
Enables/disables support for SNMP.
Port
Specify the port and protocol the LPS-20x will use to respond to SNMP requests. The default port is 161.
SNMP Protocol
Specify the SNMP version.
TRAPS
Enables/disables support for SNMP traps. The LPS-20x supports the following MIB II traps:
• coldStart
• linkUp
• linkDown
• authenticationFailure
In addition, the LPS-20x supports a number of ADC-specific traps as described in the MIBs. The MIBs are available
from ADC.
Community Name
Specify the password required by the remote host that will receive the trap.
Host
Specify the IP address or domain name of the host that the LPS-20x will send traps to.
Port
Specify the port that the LPS-20x will send traps on. By default, port 162 is used.
Configure Traps
Click this button to customize certain traps.
SECURITY
Allowed Addresses
Lets you define a list of IP addresses from which access to the SNMP interface is permitted. To add an entry,
specify the IP address and appropriate mask and click Add.
When the list is empty, access is permitted from any IP address.
Active Interfaces
Choose the interfaces through which client stations will be able to access the SNMP interface.