User's Manual Part 1

December 20, 2004 SCP-LPS20x-011-012-01H
ADC Telecommunications, Inc. 51
CONFIGURING REMOTE MANAGEMENT SUPPORT
If the LPS-20x is installed behind an access controller or RADIUS server, enabling remote access to the
management tool requires configuration settings to be defined on the access controller, RADIUS server, and the
LPS-20x. This section explains how to accomplish this for the following two scenarios (Figure 16):
Figure 16. Configuring Remote Management Support
To reach the management tool, the management stations specify the following addresses in their web browsers:
SCENARIO 1
• To reach LPS-20x A: HTTPS://192.168.10.1:5002
• To reach LPS-20x B: HTTPS://192.168.10.1:5003
SCENARIO 2
• To reach LPS-20x A: HTTPS://192.168.30.2:5002
• To reach LPS-20x B: HTTPS://192.168.30.2:5003
Static NAT mappings are used on the access controller to direct traffic to the proper LPS-20x. MAC address
authentication enables the LPS-20xs to log into the public access network. Access list definitions allow traffic to be
sent from the LPS-20xs to the management stations.
The following sections explain these configuration settings in more detail.
26-LPS20xR1
LPS-20x
LPS-20x
Internet
Access
Controller
RADIUS
Server
192.168.10.0
192.168.20.0
Management
Station
20.1 20.4
192.168.1.0
S
cenario 1
LPS-20x
LPS-20x
Internet
A
ccess
Controller
RADIUS
Server
30.1
Management
Station
20.2
20.3
192.168.1.0
Scenario 2
10.1
30.2
VPN Server
192.168.20.0
VPN Tunnel
20.1
30.3
A
B
A
B