User's Manual Part 1

SCP-LPS20x-011-012-01H December 20, 2004
38 ADC Telecommunications, Inc.
STARTING THE MANAGEMENT TOOL
1. Start your Web browser.
2. In the address box, specify:
HTTPS://192.168.1.1.
3. Press Enter. You will be prompted to accept an ADC security certificate. Do so to continue. To eliminate
this warning message, you can install your own certificate as described in SSL Certificates on page 139.
4. After you accept the ADC certificate, the management tool login page opens. By default, the username is
set to admin and the password is set to admin.
Most of the screens in this software section were captured using the LPS-202. However, the content of
screens remain the same for all LPS-20x (unless otherwise noted).
Make sure that you specify HTTPS and not HTTP.
To safeguard the security of the LPS-20x, access to the management tool must occur via a secure
connection. Before this connection can be established, you must accept an ADC security certificate. The
procedure for accepting the certificate varies depending on the browser you are using.