User's Manual Part 1

December 20, 2004 SCP-LPS20x-011-012-01H
ADC Telecommunications, Inc. 37
CONNECTING TO THE LPS-20X FOR THE FIRST TIME
Your LPS-20x is factory configured with a static IP address assignment. The address is 192.168.1.1. In order to
connect to the LPS-20x, a computer with a WLAN or LAN NIC card is required.
It is recommended that you access the LPS-20x via a wireless connection. However, you may also connect via the
wired LAN port located on the electronics enclosure.
ASSUMPTIONS
It is assumed that the LPS-20x has already been installed and wired to the xDSL as noted in section Installation and
Test on page 19. You cannot perform any configuration on this device until power has been applied.
SETUP
1. Configure your computer with the following static IP address: 192.168.1.2. This puts your computer on the
same logical network segment as the LPS-20x. This is required so that you can gain access to the manage-
ment tool.
2. Establish a wireless connection with the LPS-20x or connect the wired LAN connector on the LPS-20x to
your computer using a cross-over Ethernet cable.
3. You are now ready to start the management tool and configure the LPS-20x.
AP STATIC IP CONFIGURATION
Please refer to Setting a Static IP Address on page 84 if you are going to install this access point into your network
with a static IP address.
AP DHCP CONFIGURATION
Please refer to Network Port Configuration on page 81 if you are going to install this access point into your network
as a DHCP client.