User's Manual Part 1

SCP-LPS20x-011-012-01H December 20, 2004
28 ADC Telecommunications, Inc.
RESTARTING
Press and release the button from 1 to <5 seconds to restart the LPS-20x. This is equivalent to cycling the power.
The LPS-20x will restart immediately.
RESETTING TO FACTORY DEFAULTS
To reset the LPS-20x to its factory default settings, do the following:
CLOSE THE UNIT
To close the unit:
WARNING
Do not press the reset button for more than 5 seconds. Doing so will cause the LPS-20x to revert
to the factory defaults.
Restarting will drop all active connections.
CAUTION
Resetting the LPS-20x deletes all your configuration settings, resets the Administrator username
and password to ‘admin’ , and sets the Wireless port and LAN port IP address to 192.168.1.1.
The management tool can also be used to restart or reset the LPS-20x.
Step Action
1 Press and hold the reset button for more than 5 seconds. All the lights on the LPS-20x front panel will
light up.
2 When the lights begin to flash (after about five seconds), release the button.
3 The LPS-20x will restart with factory default settings. When the xDSL LED stops flashing, the LPS-20x
is fully operational.
Failure to close the access door leaves the interior exposed to the environment. This shortens the life span
of the components.
Step Action
1 Close the front cover.
2 Tighten the tamper proof screw on the front cover until it is completely seated.