User's Manual

Page 40 InterReach picoBTS Installation Guide
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 4 - On-Line Testing
4.2.4 RX SIGNAL QUALITY MEASUREMENTS
The objectives of this test are to verify the performance of the Receive path of the picoBTS
and the operation of the RX module in the TRX. Before these tests can take place, the picoBTS
must be returned to its original “on air” working state with call processing possible.
1 From an Xterm window on the OMC-R, telnet to the picoBTS to be tested, or alternatively
connect directly using a serial session to the picoBTS with the laptop PC.
THIS SECTION FROM HERE IS TOO BE DETERMINED.
2 From the picoBTS prompt type the following to activate the RX RSSI and quality data
logging:
HD:iwbox-> log_none [ENTER]
HD:iwbox-> ho_log_on_bts [ENTER]
5TCHYes
6TCHYes
7TCHYes
Second TRX (Note) 0 TCH Yes
1TCHYes
2TCHYes
3TCHYes
4TCHYes
5TCHYes
6TCHYes
7TCHYes
Note: The BCCH can be assigned to any TRX within the picoBTS. The label “First TRX” applies to the
TRX to which is assigned the BCCH. All TCH timeslots on the secondTRX must be tested.
Table 4-1: Timeslots Requiring Testing in picoBTS, continued
TRX NUMBER TIMESLOT NUMBER CHANNEL TYPE TESTING NECESSARY
Preliminary