User's Manual

Page 32 InterReach picoBTS Installation Guide
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 3 - Commissioning and Configuration
3.4.2 VERIFYING THE SOFTWARE LICENSE
In this section you will complete the following procedures:
• Backup the software license files from the processor card to the PC or OMC.
• Verify the software license files are compatible with the system.
1 Verify the serial cable is connected to the chassis and you have an open serial session as
detailed in Section 3.2.2.
2 Verify the license file using the following command:
printLicenseKey
The following output is a sample of properly configured license file:
License Keys :
printLicenseKey
GENERAL : VALID
GPRS : VALID
FREQHOP : VALID
XTNDCELL : VALID
SECTOR : VALID
TRX_84 : VALID
PDCH_60 : VALID
value = 1 = 0x1
HD:iwbox-> Done.
The licenses will vary depending based on your sales order and your network
configuration. Your license will not have all of the the entries listed above and may
display an error message similar to the following:
1219117434.733 (tShell) VerifyKey: key not found 4
This is normal, however if your license does not have any VALID entries. The file may be
corrupt or not properly installed, contact Customer Service.
3.4.3 REBOOTING THE PICOBTS
• Using the serial session window, reboot the picoBTS by typing:
reboot [ENTER]
The entire chassis will now reboot.
Preliminary