User's Manual

InterReach picoBTS Installation Guide Page 31
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 3 - Commissioning and Configuration
3.4 SOFTWARE VERIFICATION
You should use the following commissioning procedures to verify the software installed on the
picoBTS.
3.4.1 VERIFYING THE CURRENT SOFTWARE VERSION AND PATCH LEVEL
1 If not already done, establish serial communications with the picoBTS as described in
Section 3.2.2.
2After the
HD:iwbox-> prompt appears, verify the current software version and patch
level by typing:
iwversion [ENTER]
The following software information will be displayed:
BSC code version: iw07_05.ZZZ
Release number: 7.5
ABIS version: 1.1
Packages Installed:
Encryption: A5/1
Patches Installed:
patch<#> <file directory> <patch size> <iw07_05.ZZZ>
The current software version is displayed, represented above by the parameter iw07_05.ZZZ.
This number should correspond to the software version detailed in the release notes included
with the CD-ROM. Keep this number for your records.
3 Verify under
Patches Installed: that the most current patch is installed, if appli-
cable. Refer to the GSM Craft PC User Guide for procedures to install required patches. If
you are unsure if you require software patches, contact your Level 2 support representa-
tive for additional assistance.
Note: The following section describes procedures performed using the Craft PC. For more information
pertaining to the use of the Craft PC, please refer to the GSM Craft PC User Guide.
Note: If the displayed software version number does not coincide with the software version being run
on the network for which this
picoBTS is going to be used, contact Customer Service for instructions
on how to install a different software version.
Preliminary