User's Manual

InterReach picoBTS Installation Guide Page 29
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 3 - Commissioning and Configuration
It is necessary to change the default picoBTS Ethernet address to match your site-specific
network configuration. Use the following steps to modify the IP address and target name of the
picoBTS.
5 Type the bootChange command to edit the boot parameters. The parameters will be
displayed one line at a time.
bootChange [ENTER]
'.' = clear field; '-' = go to previous field; ^D = quit
boot device : ata.0
processor number : 0
host name :
file name : hd0:/vxWorks
inet on ethernet (e) : 172.16.80.42:fffff000
inet on backplane (b):
host inet (h) :
gateway inet (g) :
user (u) : target
ftp password (pw) (blank = use rsh):
flags (f) : 0x0
target name (tn) : iwbox
startup script (s) : /hd0/iwvstart
other (o) : motfcc
value = 0 = 0x0
HD:iwbox-> _
Figure 3-4: Default Boot Parameters
'.' = clear field; '-' = go to previous field; ^D = quit
boot device : ata.0
processor number : 0
host name :
file name : hd0:/vxWorks
inet on ethernet (e) :
XXX.XXX.XXX.XXX:fffff000
inet on backplane (b):
host inet (h) :
gateway inet (g) :
YYY.YYY.YYY.YYY
user (u) :
ftp password (pw) (blank = use rsh):
flags (f) : 0x0
target name (tn) :
TARGETNAME
startup script (s) : /hd0/iwvstart
other (o) : motfcc
value = 0 = 0x0
HD:iwbox-> _
Figure 3-5: Boot Parameters Requiring Changes
Preliminary