User's Manual

InterReach picoBTS Installation Guide Page 25
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 3 - Commissioning and Configuration
1 If not already done, connect the laptop to the picoBTS as described in Section 3.2.2,.
2 You may use any available application to open a serial connection. This procedure
decribes how to use HyperTerminal. Navigation to the program may differ depending on
the operating system you have installed.
A Launch the application by navigating: Start -> Programs -> Accessories ->
HyperTerminal -> HyperTerminal
BEnter
BSS for the connection name and select an icon. Then click the OK button.
C The Connect To dialog box displays. Select COM1 from the
Connect using
drop-down list. If you know that your serial port is configured on a different port,
select that port from this drop-down list.
D The COM1 Properties dialog box displays. Set the following properties and click the
OK button. See Figure 3-2.
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Figure 3-2: Serial Session Properties
Preliminary