User's Manual
Table Of Contents
- InterReach picoBTS Installation and Commissioning Guide
- TABLE OF CONTENTS
- Chapter 1 - Unpacking and Configuration Verification
- Chapter 2 - Installation
- Chapter 3 - Commissioning and Configuration
- Chapter 4 - On-Line Testing
Page 22 InterReach picoBTS Installation Guide
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 3 - Commissioning and Configuration
The commissioning process includes the following steps:
• Pre off-line commissioning, where you ensure that the system is in an appropriate state.
This includes:
- Visual inspection
- Compliance checks
• Startup Verification, where you verify that the system comes up correctly by observing the
LEDs on the front panel.
• Configuration includes setting up the site-specific local IP address for the picoBTS.
The rest of this chapter includes the detailed instructions for these steps.
WARNING: Under normal operating conditions, ADC Telecommunications radio equipment
complies with the limits for human exposure to radio frequency (RF) fields adopted by the Federal
Communications Commission (FCC). All ADC Telecommunications, Inc. radio equipment is designed
so that under normal working conditions radio frequency radiation directly from the radio is negligible
when compared with the permissible limit of continuous daily exposure recommended in the United
States of America by ANSI/IEEE C95.1-19991 (R1997), Safety Levels with Respect to Human
Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
Radio frequency signal levels that give rise to hazardous radiation levels can exist within the transmit-
ter, power amplifiers, associated RF multiplexers and antenna systems.
Do not disconnect RF coaxial connectors on the ADC equipment or antenna systems while the radio
equipment is operating.
Never place any body part over or look into any RF connector while the radio
equipment is transmitting.
Caution: The BSS software used in the is highly complex. Before proceeding, contact Customer
Service to verify that you have the latest available software. You must
have the correct software
CD-ROM and
know the current patch level for your software version before commissioning the
picoBTS. Contact your Level 2 support representative for additional assistance.
Preliminary