User's Manual
Table Of Contents
- InterReach picoBTS Installation and Commissioning Guide
- TABLE OF CONTENTS
- Chapter 1 - Unpacking and Configuration Verification
- Chapter 2 - Installation
- Chapter 3 - Commissioning and Configuration
- Chapter 4 - On-Line Testing
Page 18 InterReach picoBTS Installation Guide
© 2008, ADC Telecommunications, Inc.
ADCP-77-061 • Issue A • 08/2008 • Chapter 2 - Installation
2.6 NETWORK CONNECTION
External cabling is dependent upon the customer site-specific requirements. The picoBTS
system carries OAM and VoIP traffic over Ethernet and should be connected on an isolated
Ethernet subnet for best performance.
The picoBTS has two 100baseT RJ-45 connectors Ethernet connection on the front panel
labeled
WAN IN and WAN OUT, as shown in Figure 2-8.
• To make the connection, an Ethernet patch cable into the port and set up the Ethernet
connection as described in Section 3.3.
Figure 2-8: Network Connection
Preliminary