User's Manual

ADCP-75-246 • Issue 1 • 6/2008
Page 14
© 2008, ADC Telecommunications, Inc.
5. Locate the two 3/8 x 1-inch cap screws (provided with enclosure) and place a 3/8-inch
lock washer and 3/8-inch flat washer on each screw.
6. Place the mounting bracket in position for mounting on the wall and then thread the 3/8 x
1-inch cap screws (with installed washers) into the two anchors. Tighten cap screws until
secure.
7. Hang the enclosure from the mounting bracket as shown in Section 5.4.
5.3.3 Wooden Utility Pole Mounting
When mounting the enclosure from a wooden utility pole, make sure the pole is sound and has
not been damaged or weakened by decay. Use the following procedure to install the standard
mounting bracket on a wooden utility pole:
1. Hold the enclosure mounting bracket in position for installation on the wooden pole as
shown in Figure 7. The end with the V-notch should be at the top.
2. Using a pencil, mark the location of the mounting bracket’s two mounting holes on the
pole.
3. Mark the location of the mounting bracket’s two mounting holes on the wooden pole.
Figure 7. Secure Standard Mounting Bracket to a Wooden Pole
22634-A
MOUNTING
BRACKET
3/8 x 1-1/2-INCH
LAG SCREW (4)
3/8-INCH FLAT
WASHER (4)
3/8-INCH LOCK
WASHER (4)