User's Manual

Mailing Address: P.O. Box 1101, Minneapolis, Minnesota 55440-1101

World Headquarters: Minneapolis, Minnesota USA +1.952.938.8080 www.adc.com

Addendum CENG0210_XB Hardware Installation – nanoBTS

FlexWave™ microBTS

Operation and Maintenance Manual Addendum

PRODUCT DESCRIPTION

This publication provides basic information about the FlexWave™ microBTS. Place

this addendum with CENG0210_XB Hardware Installation manual for the nanoBTS.

The FlexWave microBTS provides the same functionality as the nanoBTS. However,

the microBTS utilizes an additional Linear Power Amplifier, and combines four nanoBTS units

into one single chassis. This chassis is functional for indoor and outdoor installation. The

chassis provides the degree of protection specified by NEMA 6 and IP67 as defined by IEC

Publication 60529.

INSTALLATION OVERVIEW

Mounting

The microBTS may be mounted on a flat vertical surface (such as the side of a

building) or on a utility pole. A combination wall/pole mounting bracket is provided with

each unit. A separate stand mount kit (accessory item) is available if it is necessary to

mount the microBTS from a cable. A grounding lug is provided on the bottom of the

microBTS enclosure for connecting a grounding wire.

PAGE 1
Addendum CENG0210_XB Hardware Installation – nanoBTS FlexWave™ microBTS Operation and Maintenance Manual Addendum PRODUCT DESCRIPTION This publication provides basic information about the FlexWave™ microBTS. Place this addendum with CENG0210_XB Hardware Installation manual for the nanoBTS. The FlexWave microBTS provides the same functionality as the nanoBTS. However, the microBTS utilizes an additional Linear Power Amplifier, and combines four nanoBTS units into one single chassis.
PAGE 2
FlexWave™ microBTS Nominal Specifications: PARAMETER SPECIFICATION System bandwidth 60 MHz Frequency range 1930 – 1990 MHz Out-of-band emissions -13 dBm per 1 MHz bandwidth from 30 MHz to 20 GHz Passband Gain 18.5 dB Composite RF Output power (see Note 1 at end of table) 41.5 dBm (14.13 Watts) at antenna port Gain variation ± 3 dB over temp and unit-tounit Gain flatness Band flatness Channel flatness Mounting Operating Temperature Antenna Connector Voltage Input ± 1.5 dB across freq. range ± 1.