User Manual

Page 56 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 5 - microBTS Initial Configuration
2 Using the configuration screen, type in the following information as shown in Table 5-1
E
Table 5-1: Configuration Parameters
Parameter Variable
microBTS Address
Use an IP address assigned by your system
administrator
Subnet Mask
Use an IP address assigned by your system
administrator
Gateway
Use an IP address assigned by your system
administrator
nanoBTS 1
Use an IP address assigned by your system
administrator
nanoBTS 2
Use an IP address assigned by your system
administrator
Primary OML (operations and maintenance link) 1
Use the IP address assigned to the Abis link on which
your BSC is operating
Primary OML (operations and maintenance link) 2
Use the IP address assigned to the Abis link on which
your BSC is operating a secondary link
Use DHCP
This is selected when a DHCP address needs to be
assigned to the microBTS.
Make sure that this is not selected
if you are assigning
static IP addresses