User Manual

Page 50 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 5 - microBTS Initial Configuration
15 Input a base IP number within the range of the OML Link IP address.
The number of addresses needed (1 x 1 configurations will need two addresses where as
the 2 x 1 will require 3). Click on OK. Refer to Figure 5-10.
Note: When setting the address range in the IP Pool, the range must be in the same range as the
OML/Abis link IP address. For example, if the OML Link IP address is 172.16.99.1, use a
range close to this, such as 172.16.99.11 through 172.16.99.15.
Figure 5-10: Adding an IP Address Range
1.) Select the base IP
Address
2.) Select the Number of IP addresses
Needed for Your Terminal (1 x 1
Systems require 2 addresses and
2 x 1 systems require 3)
AD068905
3.) Select OK and New
IP addresses Will Be
Assigned To The
MicroBTS Units
In Sequential Order