User Manual
Table Of Contents
- FlexWave microBTS 1 x 1 and 2 x 1 Installation and Commissioning Guide
- Chapter 1 - Introduction
- Chapter 2 - Unpacking and Inspection
- Chapter 3 - Mounting Procedures
- Chapter 4 - Installation Procedures
- 4.1 Installation Overview
- 4.1.1 Installation Hardware Provided with microBTS Enclosure
- 4.1.2 Tools and Materials Required
- 4.1.3 Ground Wire Installation
- 4.1.4 Network Listen Antenna Installation
- 4.1.5 IP Backhaul Cable Installation
- 4.1.6 Base Station Antenna Cable Installation
- 4.1.7 AC Power Wiring Installation
- 4.1.8 DC Power Wiring Installation
- 4.1.9 Touch-Up Painting
- 4.1.10 Shield Installation (option)
- 4.2 microBTS Replacement
- 4.1 Installation Overview
- Chapter 5 - microBTS Initial Configuration
Page 46 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 5 - microBTS Initial Configuration
5 Referring to Figure 5-5 click on the IP Address Configure button.
6A Configure BTS Installer screen will appear as shown in Figure 5-6.
7 A list of Network Adaptors and IP addresses will be shown.
8 Click on the + (plus) symbol to view the detail of the network adaptor card in your PC.
The IP address which was set in the previous steps will appear.
9 Highlight this address and it will appear in the DHCP Server IP Address dialog box.
10 Leave the Listen Only on This Address check box unchecked.
11 Click on the OK button.
Figure 5-5: The Main Configuration Screen Showing the MAC Address of Each microBTS and TRX
AD077904