User Manual
Table Of Contents
- FlexWave microBTS 1 x 1 and 2 x 1 Installation and Commissioning Guide
- Chapter 1 - Introduction
- Chapter 2 - Unpacking and Inspection
- Chapter 3 - Mounting Procedures
- Chapter 4 - Installation Procedures
- 4.1 Installation Overview
- 4.1.1 Installation Hardware Provided with microBTS Enclosure
- 4.1.2 Tools and Materials Required
- 4.1.3 Ground Wire Installation
- 4.1.4 Network Listen Antenna Installation
- 4.1.5 IP Backhaul Cable Installation
- 4.1.6 Base Station Antenna Cable Installation
- 4.1.7 AC Power Wiring Installation
- 4.1.8 DC Power Wiring Installation
- 4.1.9 Touch-Up Painting
- 4.1.10 Shield Installation (option)
- 4.2 microBTS Replacement
- 4.1 Installation Overview
- Chapter 5 - microBTS Initial Configuration
FlexWave microBTS Installation and Commissioning Guide Page 45
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 5 - microBTS Initial Configuration
5.4 Determining the MAC Address of the microBTS and Assigning DHCP IP
Addresses
Use the following step-by-step procedure to assign an IP address to the microBTS terminal.
1 Connect the microBTS terminal to the AC/DC power source. The red LED alarm
indication will illuminate for about 5 minutes and extinguish once the terminal has
completed its start cycle.
2 Power on the Ethernet router/switch and PC.
3 Launch the BTS Installer utility from the PC desktop or folder as shown in Figure 5-4.
4 Once the BTS Installer is launched, the main configuration screen will appear as shown in
Figure 5-5.
Figure 5-4: Launching the BTS Installer
AD068901
Launch
The BTS
Installer