User Manual
Table Of Contents
- FlexWave microBTS 1 x 1 and 2 x 1 Installation and Commissioning Guide
- Chapter 1 - Introduction
- Chapter 2 - Unpacking and Inspection
- Chapter 3 - Mounting Procedures
- Chapter 4 - Installation Procedures
- 4.1 Installation Overview
- 4.1.1 Installation Hardware Provided with microBTS Enclosure
- 4.1.2 Tools and Materials Required
- 4.1.3 Ground Wire Installation
- 4.1.4 Network Listen Antenna Installation
- 4.1.5 IP Backhaul Cable Installation
- 4.1.6 Base Station Antenna Cable Installation
- 4.1.7 AC Power Wiring Installation
- 4.1.8 DC Power Wiring Installation
- 4.1.9 Touch-Up Painting
- 4.1.10 Shield Installation (option)
- 4.2 microBTS Replacement
- 4.1 Installation Overview
- Chapter 5 - microBTS Initial Configuration
FlexWave microBTS Installation and Commissioning Guide Page 43
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 5 - microBTS Initial Configuration
5.3 Configure PC to Communicate with the microBTS
1 To allow the PC to communicate with the configuration shown in Figure 5-1, the PC
network card must be configured with the correct IP address. If the microBTS is already
connected to the BSC via an Abis link use the Abis IP address. If the microBTS is not
connected to the BSC, determine the IP address of your PC by opening the Command
Prompt and type in “ipconfig” and use this address. The IP address shown is that of your
PC. Refer to Figure 5-2.
2 Open the Internet Protocol Properties screen of your PC network interface card and assign
the IP address discovered in the previous step as shown in Figure 5-2. If you are already
connected to the BSC via an Abis link select the Obtain an IP address automatically
button also shown in Figure 5-3.
Figure 5-2: The Command Prompt Screen Showing the IP Address of the PC
AD077914