User Manual
Table Of Contents
- FlexWave microBTS 1 x 1 and 2 x 1 Installation and Commissioning Guide
- Chapter 1 - Introduction
- Chapter 2 - Unpacking and Inspection
- Chapter 3 - Mounting Procedures
- Chapter 4 - Installation Procedures
- 4.1 Installation Overview
- 4.1.1 Installation Hardware Provided with microBTS Enclosure
- 4.1.2 Tools and Materials Required
- 4.1.3 Ground Wire Installation
- 4.1.4 Network Listen Antenna Installation
- 4.1.5 IP Backhaul Cable Installation
- 4.1.6 Base Station Antenna Cable Installation
- 4.1.7 AC Power Wiring Installation
- 4.1.8 DC Power Wiring Installation
- 4.1.9 Touch-Up Painting
- 4.1.10 Shield Installation (option)
- 4.2 microBTS Replacement
- 4.1 Installation Overview
- Chapter 5 - microBTS Initial Configuration
Page 38 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 4 - Installation Procedures
4.2 MICROBTS REPLACEMENT
The microBTS enclosure contains no user-serviceable or field-serviceable components.
Failure of any internal component will require replacement of the entire unit. The enclosure
mounting hardware, the various cables, and any attached items may be reused with the replace-
ment unit. Opening the microBTS enclosure for any reason may cause the product warranty to
be voided.
Service to be conducted by qualified ADC service personnel only.
Figure 4-9: Solar shield Installation
Caution; Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries
according to manufactures instructions.
3/8-INCH HEX
STANDOFF (7)
#10 SPLIT
WASHER (7)
3/8-INCH 10-32 SCREW
WITH T25 TORX DRIVE (7)
22153-A