User Manual

Page 36 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 4 - Installation Procedures
3 Secure the cable between the DC power port and the DC power breaker box per local prac-
tice. Leave sufficient slack in the cable to allow it to be easily connected and disconnected
from the DC supply.
4 Install any DC power supply wires that may be required between the DC breaker box and
the DC supply.
5 Connect the DC power cable wires to the DC power supply. Refer to Figure 4-8 and
Table 4-1 shown below to identify the color code and wire designations.
Figure 4-8: Typical DC Power Cable Routing Detail
Note: The power cable is rated for indoor or outdoor use and must not be placed within electrical
conduit as this will impede the cooling of the cable during usage. The cable run distance to the DC
power source must not exceed 100 feet.
FlexWave microBTS
AD078901
End View of Cable Connector (48 VDC Power)
PIN 1: Ground (Green/ Yellow)
PIN 2: Negative (White)
Pin 3: Positive (Black)
Return Voltage
5 amp, 48 VDC Power Source
Breaker/ Junction Box Equipped with
5 amp breaker . Installed According to
Local Regulations.
White- Negative
Black- Positive/ Return
Green/ Yellow- Ground
Cable Color Code Detail (48 VDC Power)