User Manual

Table Of Contents

Page 32 FlexWave microBTS Installation and Commissioning Guide

ADCP-77-086 • Issue 2 • 04/2009 • Chapter 4 - Installation Procedures

Use the following procedure to install the AC power wiring:

1 Locate the AC power cable that is provided separately with the enclosure.

2 Route the power cable between the AC power port, located on the underside of the enclo-

sure and the nearest AC power junction box as shown in Figure 4-5. It may be necessary to

install a new junction box if an existing junction box is not available.

3 Secure the cable between the AC power port and the AC power junction box per local

practice. Leave sufficient slack in the cable to allow it to be easily connected and discon-

nected from the AC power port.

Note: All electrical work must comply with local codes and requirements. A locally licensed electri-

cal contractor is best qualified to perform this work. For additional information, consult with the ADC

Customer Service.

DANGER: Use extreme caution when working with high voltage AC power. Ensure all power is dis-

connected before working on power circuits.

Figure 4-5: Typical AC Power Cable Routing

microBTS

ENCLOSURE

22087-A

AC POWER

JUNCTION BOX

AC POWER

CABLE

AC POWER

WIRES ROUTED

TO CIRCUIT

BREAKER PANEL