User Manual
Table Of Contents
- FlexWave microBTS 1 x 1 and 2 x 1 Installation and Commissioning Guide
- Chapter 1 - Introduction
- Chapter 2 - Unpacking and Inspection
- Chapter 3 - Mounting Procedures
- Chapter 4 - Installation Procedures
- 4.1 Installation Overview
- 4.1.1 Installation Hardware Provided with microBTS Enclosure
- 4.1.2 Tools and Materials Required
- 4.1.3 Ground Wire Installation
- 4.1.4 Network Listen Antenna Installation
- 4.1.5 IP Backhaul Cable Installation
- 4.1.6 Base Station Antenna Cable Installation
- 4.1.7 AC Power Wiring Installation
- 4.1.8 DC Power Wiring Installation
- 4.1.9 Touch-Up Painting
- 4.1.10 Shield Installation (option)
- 4.2 microBTS Replacement
- 4.1 Installation Overview
- Chapter 5 - microBTS Initial Configuration
Page 22 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 3 - Mounting Procedures
2 Wrap the top section of strapping around the pole and secure using Panduit tool # BT1HT.
Adjust the tool tension setting to #7. Follow the instructions provided with the tool by the
tool manufacturer (see MS Strapping Tool Operation Instructions PA24808A01).
3 Repeat step 2 for the bottom section of strapping.
4 Hang the enclosure from the mounting bracket as shown in Section 5.4.
3.1.7.5 Installing the Enclosure on the Standard Mounting Bracket
Use the following procedure to install the microBTS on the standard mounting bracket.
Figure 3-6: Secure Standard Mounting Bracket To a Metal Pole
20767-D
3/8 x 1-1/2-INCH
LAG SCREW (4)
3/8-INCH FLAT
WASHER (4)
3/8-INCH LOCK
WASHER (4)
MOUNTING
BRACKET