User Manual

Page 20 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 3 - Mounting Procedures
5 Locate the two 3/8 x 1-inch cap screws (provided with enclosure) and place a 3/8 inch lock
washer and 3/8 inch flat washer on each screw.
6 Place the mounting bracket in position for mounting on the wall and then thread the 3/8 x
1 inch cap screws (with installed washers) into the two anchors. Tighten cap screws until
secure.
7 Hang the enclosure from the mounting bracket as shown in Section 5.4.
3.1.7.3 Wooden Utility Pole Mounting
When mounting the enclosure from a wooden utility pole, make sure the pole is sound and has
not been damaged or weakened by decay. Use the following procedure to install the standard
mounting bracket on a wooden utility pole:
1 Hold the enclosure mounting bracket in position for installation on the wooden pole as
shown in Figure 3-5. The end with the V-notch should be at the top.
2 Using a pencil, mark the location of the mounting bracket’s two mounting holes on the
pole.
3 Mark the location of the mounting bracket’s two mounting holes on the wooden pole.
Figure 3-5: Secure Standard Mounting Bracket To a Wooden Pole
20767-D
3/8 x 1-1/2-INCH
LAG SCREW (4)
3/8-INCH FLAT
WASHER (4)
3/8-INCH LOCK
WASHER (4)
MOUNTING
BRACKET