User's Manual

Installing Fusion Wideband
Page 142 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2015 TE Connectivity D-620616-0-20 Rev K • TECP-77-044 Issue 9 • March 2015
11 Use the scroll bar on the left side of the page to scroll down to view the rest of the page as
shown below.
12 In
the Bands pa
nel, do the following:
• You should not have to use the Bands m
enu to select the bands. The system self configures
the band by validating that all the RAUs connected are the same type.
• Wh
en both bands are not configured, use the S
hutdown check boxes. The system will
ignore any alarms generated from the bands that have been shutdown.
• Use the Uplink Gain and
Downlink Gain menus to select the gain for each band. You can set
system gain within the specified range in 1 dB increments.
• Use the Uplink Automatic Level Control
menu to select either Single or Multiple (default)
for each band in the system.