User's Manual

Installing Fusion Wideband
Page 108 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2015 TE Connectivity D-620616-0-20 Rev K • TECP-77-044 Issue 9 • March 2015
TE recommends connectors with fixed centerpins to ensure proper seating and to eliminate
oxidation, which occurs with bare center conductors. TE recommends the following CANARE
connectors:
• FP-C4F for CommScope 2065V cable
• FP-C55A for CommScope 2279V cable
• FP-C71A for CommScope 2293K cable
CAUTION! The proper crimp tool and die must be matched by the connector type.
Distance Requirements
Table 88 shows the distances between Fusion Wideband components and related equipment.
Table 88.
Distance Requirements
Equipment
Combination
Cable Type Cable Length Additional Information
Repeater/BTS to
Fusion Wideband
Main Hub
Coaxial; N male
connectors
3–6 m (10–20 ft) typical Limited by loss and noise.
Refer to your link budget
calculation.
10 m (33 ft) maximum Limited by CE Mark
requirements.
Fusion Wideband
Expansion Hub
to
RAU
CATV 75 Ohm;
shielded F male
connectors
Minimum: 10 meters (33 ft)
Maximum:
150 meters (492 ft) for RG-59;
170 meters (558 ft) for RG-6;
275 meters (902 ft) for RG-11
Refer to Table 39 on page 53 and Table 40 on
page 54.
Refer to “System Gain” on
page 82.
Main Hub to
Expansion Hub
Multi-mode fiber:
Single-mode fiber:
S
C/APC male
connectors
500 m (1640 ft.) maximum
6 km (19,685 ft.) maximum
Limited by 3 dB optical
attenuation
RAU to passive
antenna
Coaxial; N male
connectors
1–3
.5 m (3–12 ft) typical Limited by loss and noise.
Refer to your link budget
calculation.