User Manual

InterReach Fusion Wideband Installation, Operation, and Reference Manual 7-1
D-620616-0-20 Rev G CONFIDENTIAL
SECTION 7 Installing Fusion Wideband
This section contains the following subsections:
• Section 7.1 Installation Requirements 7-1
• Section 7.2 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-3
• Section 7.3 Preparing for System Installation . . . . . . . . . . . . . . . . . . . . . . . . . 7-6
• Section 7.4 Fusion Wideband Installation Procedures . . . . . . . . . . . . . . . . . 7-10
• Section 7.5 Splicing Fiber Optic Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-45
• Section 7.6 Interfacing the Fusion Wideband Main Hub to an RF Source . . 7-47
• Section 7.7 Connecting Contact Alarms to a Fusion Wideband System . . . . 7-58
• Section 7.8 Alarm Monitoring Connectivity Options . . . . . . . . . . . . . . . . . . 7-66
7.1 Installation Requirements
Before and during installation, keep in mind these sources of potential problems:
• Faulty cabling/connector
• Dirty connectors and ports
• Malfunction of one or more Fusion Wideband components
• Antenna, base station, or repeater problem
• External RF interface
• Tripped circuit breaker
• Equipment is not grounded
• Using a crossover Ethernet cable that does not support full hardware handshaking
when using AdminBrowser