User's Manual Part 2

ManualsBrandsADC Telecommunications ManualsElectronicsInterReach Fusion 700 MHz (Upper C) , AWS MIMO HP

100

Appendix C: Faults, Warnings, Status Tables for Fusion, Fusion Wideband, Fusion SingleStar

Page 226 InterReach Fusion Wideband Installation, Operation, and Reference Manual

MESSAGESFORRAUS

ͳͲͷǡǣ

[Rnn]/X



• nn

• X

– S—

– W—Ǥ

Table105. Warning/StatusMessagesforRAUs

Message 

Number

Default

Description Reason/Action

[R01]/W Temperature High. Check RAU location for excessive temperature; check for air flow

blockage and/or incorrect installation. Move the RAU to a cooler

environment.

[R02]/W No communications from Hub. Check the cable for high RF loss. Switch the cable connection to a

different hub port. If the problem persists, replace the RAU.

[R03]/W DL RF path loss is too high. Check the cable for high RF loss. Switch the cable connection to a

different hub port. If the problem persists, replace the RAU.

[R04]/W DL RF path exceeds maximum gain. Check the Hub for proper operation; switch the cable connection

to a different hub port. If the problem persists, replace the RAU.

[R05]/S DL RF path problem (Band 1). Unable to complete the DL system end-to-end test, replace the

RAU when possible.

[R06]/S DL RF path problem (Band 2). Unable to complete the DL system end-to-end test, replace the

RAU when possible.

[R07]/S DL RF path problem (Band 3). Unable to complete the DL system end-to-end test, replace the

RAU when possible.

[R08]/S System test required. Run system test.

[R09]/W Antenna Disconnected. Check RAU antenna connection; re-run system test.

[R10]/S UL RF path problem (Band 1). Unable to complete the UL system end-to-end test, replace the

RAU when possible.

[R11]/S UL RF path problem (Band 2). Unable to complete the UL system end-to-end test, replace the

RAU when possible.

[R12]/S UL RF path problem (Band 3). Unable to complete the UL system end-to-end test, replace the

RAU when possible.

[R13]/S Problem detected in the RAU. Contact TE Support for more information.

[R14]/S Problem detected in the RAU. Contact TE Support for more information.

[R15]/S Problem detected in the RAU. Contact TE Support for more information.

[R16]/S Problem detected in the RAU. Contact TE Support for more information.

[R17]/S Antenna disconnected (Band 1). Check the RAU Band 1 antenna, then rerun the system test.

[R18]/S Antenna disconnected (Band 2). Check the RAU Band 2 antenna, then rerun the system test.

[R19]/S Hardware Failure (UL FD PLL Band 1). Unable to complete a UL system end-to-end test. Replace the RAU

when possible.

[R20]/W TDD signaling tone outside valid range (Band 1). If the Main Hub and Expansion Hub are okay, replace the RAU.