User's Manual Part 2

Installing Fusion Wideband
Page 152 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2013 TE Connectivity Ltd D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013
Ǥ
ConnectingMultipleFusionWidebandMainHubstoanRFSource
Ȁ
Ǥ
Ȁ
Ǥ
CAUTION! OnlyTEpersonnelorTEͲauthorizedinstallationpersonnelshouldconnecttheFusionWideband
MainHubtoabasestationorrepeater.Exceedingthemaximuminputpowercouldcausefailure
of the Fusion Wideband Main Hub (refer to “Remote Access Unit Connectors” on page57 for
maximum power specifications). If the maximum compositepower is too high, attenuation is
required.
1 ǣ
2 ȀǦǦ
ǣ
a ȀUPLINK
b ȀDOWNLINK
3 Ȁǣ
a ǯUPLINK ȋͳǡʹǡ͵Ȍ
Ȁ
b ǯDOWNLINK ȋͳǡʹǡ͵Ȍ
Ȁ
c ǯUPLINK ȋͳǡʹǡ͵Ȍ
Ȁ
d ǯDOWNLINK ȋͳǡʹǡ͵Ȍ
Ȁ
NOTE: ConnectionsshouldnotcrossBands.Forexample,allBand1connectionsshouldbemadetothe
samehybridpowercombiner/splitterconnectedtotherepeaterBTSthatmatchestheBand1
frequency.
3 ConnectingaFusionWidebandMainHubtoFlexwaveFocus
3
ConnectingMultipleFusionWidebandMainHubstoaSimplexRepeaterorBTS
Quantity Item
2 hybrid power combiner/splitters—one for uplink and one for downlink (2x1 for two Fusion Wideband Main
Hubs, 3x1 for three, 4x1 for four, and so on)
1 N-male to N-male coaxial jumper cable between each power combiner/splitter and the base station
2 N-male to N-male coaxial jumper cables between each power combiner/splitter and each Fusion Wideband
Main Hub RF Band (either Band 1 or Band 2)