User's Manual Part 2
Installing Fusion Wideband
Page 138 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2013 TE Connectivity Ltd D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013
CONFIGURINGTHEFUSIONWIDEBANDSYSTEM
ǡ
Ǥ
Ǥ
ǡAdminBrowserUserManualȋǦʹͲͲǦͲǦʹͲȌǡ
ȀǤ
NOTE: The frequency bands should automatically be set on power up and this step should not be
required.
NOTE: CrossoverEthernetcablewithmaleconnectorsrequired.
NOTE: Thefollowing procedures assumethatthesystem is new from the factoryand that it has not
beenprogrammedwithbands.IfyouarereplacingcomponentsinapreͲinstalledsystemwith
either new units or units that may already be programmed (for example, reͲusing units from
anothersystem),refer
to
“ReplacingFusionWidebandComponents”onpage175.
1 Ǥ
CAUTION! MakesuretheHubisgroundedthroughthegroundlugontheACpowerandtheframeground
lug as required. The warranty does not cover damage caused when an ungrounded Hub is
poweredon.
2 Ǥ
3 Ǥ
4 Ǥ
Ǥ
ȋȌǡǤSTATUS
ͻͲǤ
ǯ
Ǥ
ʹͲǤ
5 ǦȀRJ-45 100-BASE-T
ǯǤ
3 ConnectingthePCtotheMainHubtoRunAdminBrowser