User's Manual Part 1

Fusion Wideband Main Hub Front Panel
InterReach Fusion Wideband Installation, Operation, and Reference Manual Page 35
D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013 © 2013 TE Connectivity Ltd.
FusionWidebandMainHubRearPanel
Figure11.Fusion Wideband Main Hub Rear Panel
Table30. FusionWidebandHubPortLEDStates
LED State Indicates
Off • The Expansion Hub is not connected.

Green
• The Expansion Hub is connected.
• There are no faults from the Expansion Hub or any connected RAU.
Red 
(60 PPM)
• There was a loss of communications with the Expansion Hub.
Red 
(Steady)
• The Expansion Hub is disconnected.
• The Expansion Hub or any connected RAU reported a fault.
Green
(60-ppm)
• The Expansion Hub or any connected RAU reported a lockout condition.
Ref # Description
1 One 9-pin D-sub female connector labeled “Alarms” for contact alarm monitoring
2 Three N-type, female connectors for each band (Band 1, Band 2, and Band 3):
• Uplink (labeled Ul1, Ul2, and UL3)
• Downlink (labeled DL1, Dl2, and DL3)
3 Two air exhaust vents
4 AC power cord connector
5 Ground lug labeled “Ground” that connects the unit to frame ground
PORT
PORT
PORT
PORT
PORT
1 4
3
Unit is not shown to scale.
Alarms
AC Power
Band 1 Band 2 Band 3
UL1 UL2 UL3
DL1 DL2 DL3
2
5