User's Manual Part 1

Fusion Wideband Main Hub
Page 32 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2013 TE Connectivity Ltd D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013
FUSIONWIDEBANDMAINHUBFRONTPANEL
Figure10.Fusion Wideband Main Hub Front Panel
NOTE: The Fusion Wideband One Port Main Hub (PNs: FSNͲW1ͲMHͲ2Ͳ1P, FSNͲW2ͲMHͲ3Ͳ1P,
FSNͲW3ͲMHͲ1P,FSNͲW4ͲMHͲ1P,andFSNͲW5ͲMHͲ1P)configurationisacostreducedversionof
theFusionWidebandMainHubandsupportsonlyoneExpansionHub(upto
8RAUs).
Ref # Description
1 Four fiber optic ports (labeled PORT 1, PORT 2, PORT 3, PORT 4) with corresponding fiber port LEDs (one LED per port)
• One standard female SC/APC connector per port for MMF/SMF input (labeled UPLINK)
• One standard female SC/APC connector per port for MMF/SMF output (labeled DOWNLINK)
• One LED per port for port link status and downstream unit status
2 One set of unit status LEDs
• One LED for unit power status (labeled POWER)
• One LED for unit status (labeled MAIN HUB STATUS)
3 One 9-pin D-sub male connector for system remote dial-up communication and diagnostics using a modem (labeled
MODEM)
4 One RJ-45 female connector for system communication and diagnostics using a PC/laptop with direct connect or using
a LAN switch (labeled ADMIN/LAN)
5 Power switch
POWER
MAIN HUB
STATUS
UPLINK
DOWNLINK
PORT 1
PORT 2
PORT 3
PORT 4
POWER
InterReach
Wideband Fusion
Main Hub
ADMIN LANMODEM
1
2
3
45
Unit is not shown to scale.