User's Manual

Help Hot Line (U.S. only): 1-800-530-9960 7-41
D-620616-0-20 Rev F CONFIDENTIAL
Fusion Wideband Installation Procedures
Figure 7-25 AdminBrowser Configuration Window for Non WiMAX
10. In the Band area, do the following:
• You should not have to select the bands. The system self configures the band
by validating that all the RAUs connected are the same type.
• When both bands are not configured, use the Shutdown check box. The system
ignores any alarms generated from the shutdown bands.
• Use the pull-down to specify the Uplink and Downlink gain for each band. You
can set system gain within the specified range in 1 dB increments.
• Use the pull-down to set the Uplink Automatic Level Control to either “Single”
or “Multiple” for each band in the system. (The default is “Multiple.”
11. FOR WiMAX INSTALLATIONS ONLY: Use the scroll bar on the left side of
the page to scroll down to view the next part of the windows shown in
Figure 7-26.
Figure 7-26 AdminBrowser Configuration Window WiMAX ONLY
In the Band area, do the following:
• Select the Protocol mode: This configures the system to support WiMAX
radios that are one of the following:
MIMO (multiple in-multiple out)
SISO (single in-single out). The default is “MIMO”.