User's Manual Part 2

Replacing a Fusion Wideband Main Hub
InterReach Fusion Wideband Installation, Operation, and Reference Manual Page 179
D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013 © 2013 TE Connectivity Ltd.
REPLACINGAFUSIONWIDEBANDMAINHUB
YoumustrecordthesystemconfigurationsettingsfromtheoldFusionWidebandMainHub’s
memorybeforereplacingtheunit.YouwillprogramthenewMainHubwiththisinformation.If
theMainHubisprogrammedincorrectly,thesystemwillnotwork.IftheHubtobereplacedis
notfunctioningandyoucannotuseAdminBrowser,gettheconfigurationsettingsfromthe
As‐BuiltDocumentthatwascreatedaspartoftheoriginalinstallation.
1 UsingAdminBrowser,login,click
SYSTEM INFORMATION,clickSHOW SYSTEM TREE,selectFusion
WidebandHub,click
GET SYSTEM INFORMATION.
2 Turn
offthepowertotheFusionWidebandMainHub.
3 Disco
nnectallcablesandtheACpowercord.
4 Repl
acetheMainHubwithanewone.
5 Conn
ecttheACpowercordandallcables.
6 Connectthecrossover
EthernetcabletothePCandthentotheMainHub’sfrontpanel
100Base‐Tconnector.ADMIN/LANport)
7 StartthestandardbrowseronthePCtocommun
icatewithAdminBrowsersoftware.
8 TurnonthepowertotheMainHub.
9 Ob
servetheLEDsafterturningonthepower.
AlltheLEDsblinkduringtheinitialpowerupsequence.AllLED
sshouldturngreenafterthe
poweronsequenceiscomplete.Powerupsequencetakesbetween1and2minutes
dependingonthenumberofRAUs.
CAUTION! DuringSystemTest,theentiresystemistemporarilyoff‐lineandnoRFisbeingtransmitted.
1 UsingAdminBrowserandlogintotheMainHub.
2 Click
SYSTEM CONFIGURATION.
3 Click
SET DATE/TIMEandenterthecurrentdateandtime.
4 Click
SET DATE/TIME.
5 Followthe
instructionstoeventuallyrebootthesystemtosetthedateandtime.
6 U
singAdminBrowser,loginandclickSYSTEM CONFIGURATION.
7 Click
INSTALL SYSTEM.
8 Setthe
newMainHubparametersfromtheoldMainHubandclickINSTALL SYSTEM (thatis,
uplinkanddownlinkgain,systemlabels,andsoon).
9 Followthei
nstructionstoperformaSystemTest.
10 Click
SYSTEM CONFIGURATIONandclickonSETUP NETWORK CONNECTION OR MODEM CONNECTIONifthe
MainHubhasNetworkorModemequipmentconnectedtoit.
 ReplaceaFusionWidebandMainHub
 ConfiguretheNewFusionWidebandMainHub